Instructions for setting up the

RCA RCU-300

SYSTEM LINK 3

3 Component Universal Remote Control

1) Find the Component Code number for the desired Device from the table below.

 

2) On the RCA RCU-300 remote press and hold the Code Search button until the red light comes on. Now release the Code Search button.

3) Momentarily press the VCR/DVD button.

4) Enter the 3 digit Component Code on the remotes number pad. The light should blink off after each keypress and go out after the last digit. If the light instead blinks three times that means the Component Code was invalid. Start the procedure again.

The VCR preset should now be set.

 

The full instruction manual for this remote plus the complete list of Component Codes is located here --> RCA RCU-300 Manual